Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 224 User Manual with side - Page 17
Adjust the Stacker, Run the Job, Procedure for a Saved Job, Side-Trimmer Stacker, Book Stacker
View all Konica Minolta bizhub PRESS 1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
2 - How to Run the PowerSquare - Adjust the Stacker Step Action Information 9 Enter the side-trim setting. The side trim dimension is calculated auto- matically according to the PAGE SIZE. To change the size and trim position, touch SIDE TRIM. See "SIDE TRIM" on page 22. If the side-trim size is 190mm or less, remove the book supports. See "Remove and re-fit the Side-Trimmer Book Supports" on page 48. 10 Touch CLOSE. 11 If needed, save the job set- If the same job settings are used frequently, tings to memory. then save the job settings to memory. See "Save a job" on page 30. Procedure for a Saved Job 1. Touch LOAD & SAVE . 2. Touch the job name or use the Up arrow and the Down arrow to select the job. 3. Touch LOAD. 4. Wait until the PowerSquare is ready. Adjust the Stacker Side-Trimmer Stacker Adjust the stacker according to the size and thickness of the finished book. See "Adjust the Side-Trimmer Stacker" on page 45. Book Stacker Check the Book Stacker is ready to accept books. See "Adjust the Book Stacker" on page 41. Run the Job Procedure 1. Make sure the adjustments on the PowerSquare are complete before you release the print job from the print queue. 2. Start the print job. The PowerSquare starts automatically. 3. Check the quality of the first book. 4. If the quality is not acceptable, make adjustments. See "Book Quality Problems" on page 57 for further information. Watkiss PowerSquare™224 User Manual 13