Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 224 User Manual with side - Page 85
See The Side, STITCH TIMEOUT
View all Konica Minolta bizhub PRESS 1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
5 - Error Conditions, Problems and Solutions - Message List Message Information Reference SIDE TRIM - no comms Check that the mains power input cable and the communications cable are connected. See "The SideTrimmer" on page 7. Use the side-trimmer mains ON/ OFF switch. Turn the side-trimmer OFF, wait at least 5 seconds and then turn the side-trimmer ON. If the problem continues, then call your service engineer. STACKER FULL The stacker is full. Unload the books from the stacker. STACKER - No comms Check that the stacker power input is connected. Check that the stacker mains ON/ OFF switch is ON. If the problem continues, then call your service engineer. Stitch axis moving The stitch axis is moving. This message clears when the adjustment is complete. If the message does not clear, touch ADVANCED > RE-REF. Stitch length will change The stitch length cannot adjust at soon the moment. The stitch leg length will adjust after the next book. STITCH - No comms Use the mains ON/OFF switch. Turn the machine OFF, then turn the machine ON. If the problem continues, then call your service engineer. Stitch position adjusting The stitch position is adjusting. This message clears when the adjustment is complete. If the message does not clear, touch ADVANCED > RE-REF. STITCH TIMEOUT Press STOP . Open the folder cover, remove the paper, close the folder cover. Watkiss PowerSquare™224 User Manual 81