Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 224 User Manual with side - Page 60
General Problems, The PowerSquare does not start, The touch screen does not work
View all Konica Minolta bizhub PRESS 1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
5 - Error Conditions, Problems and Solutions - General Problems General Problems The PowerSquare does not start Is the touch screen illuminated? No Yes Are error messages displayed on the touch screen? No Yes See "Message List" on page 72 Is there an error message on the printer? No Yes Correct the printer error. If the printer error message is 'Check Third Party Finishing Device' or 'check custom', then check for an error message on the PowerSquare touch screen. If the problem continues, then call your service engineer. Turn OFF and turn ON the PSQ. If the problem continues, then call your service engineer. Is the touch screen in power-save mode? See "Power save" on page 16. Touch the screen to restore the normal brightness. No Yes Go back to the start of this fault-finding table. Is the mains-power ON/OFF switch illuminated? No Yes Call your service engineer. Is the PowerSquare turned ON and connected to the mains power supply of the correct type and voltage? No Yes Replace the fuse at the mains input. See "Change the Fuses PowerSquare" on page 97 If the problem continues, then call your service engineer. Connect the PowerSquare to the mains supply of the correct type and voltage and then turn the machine ON. The touch screen does not work Is the touch screen in power-save mode? See "Power save" on page 16. Touch the screen to restore the normal brightness. No Yes No further action is needed. Calibrate the touch screen. See "Calibrate the Touch Screen" on page 97. 56 Watkiss PowerSquare™224 User Manual