Kyocera KM-8030 PRESCRIBE Commands Technical Reference Manual - Rev. 4.7 - Page 114

Chapter 7 Emulation Selecting an Emulation When installing a printing system, you can select an emulation that best suits the requirement by the application software. In most cases, the emulation will be the factory default setting (mode 6: HP LaserJet). Refer to the following diagram to locate the next level emulation in case you need to change the emulation. For example, in printing environments using the HP plotter model HP 7550A (KC-GL), the user should select mode 8. In PostScript printing environments, mode 9 should be selected (an option on some models) . To set an emulation mode, send the printing system the FRPO commands listed in the table below. Table 7.1. Emulation Switching Command Sequence Mode 0 1 2 5 6 8 9 Emulation Line Printer IBM Proprinter X24E Diablo 630 Epson LQ-850 HP LaserJet HP 7550A KPDL FRPO Commands !R! FRPO P1, 0; FRPO P3, 1; EXIT; !R! FRPO P1, 1; FRPO P3, 2; EXIT; !R! FRPO P1, 2; FRPO P3, 1; EXIT; !R! FRPO P1, 5; FRPO P3, 2; EXIT; !R! FRPO P1, 6; FRPO P3, 1; EXIT; !R! FRPO P1, 8; FRPO P3, 1; EXIT; !R! FRPO P1, 9; EXIT; The emulation mode can also be changed from the printing system's operator panel. 7-2