LG N1910LZ-BF User Manual - Page 33
Enable Discovery, Session Type, Identify Peer By, Enable Auto-Reconnect, Discovery Tab
View all LG N1910LZ-BF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
EEngNliGsh Using PCoIP Solution 33 Discovery Tab The Discovery tab allows the administrator to easily find a portal in the PCoIP system. NOTE yyThe Discovery parameters can also be configured using the Webpage Administration Interface. Session Tab The Session tab allows the administrator to set the method to connect the device to a peer device. NOTE yyThe Session parameters can also be con- figured using the Webpage Administration Interface. Figure 2-9. Discovery Configuration yy Enable Discovery If the Enable Discovery option is selected, a device will use SLP Discovery to dynamically locate the peer device without requiring any information about the location of the device in the network. This means that the configuration and maintenance work in a complicated system can be significantly reduced. As SLP Discovery requires a multicast-enabled router, the recommended search structure is DNSSRV Discovery. yy Enable Host Discovery The Enable Host Discovery option allows the user to find the host not listed in the PCoIP session from the portal. When this option is enabled, up to 10 available hosts can be listed, in the order of their detection from the portal. Use the Enable Host Discovery option when there are a relatively small number of hosts. Figure 2-10. Session Configuration yy Session Type In Session Type, the administrator can configure a portal for the PCoIP session or the RDP session. yy Identify Peer By The Identify Peer By selector allows the administrator to decide whether to identify the peer device by IP, by MAC address or by FQDN. Table 2-2 shows the peer ID parameters that can be used with one of the two methods. If an incorrect IP address or DNS name is provided, an OSD message is displayed prompting the administrator to correct the error. Table 2-2. Peer ID Method yy Enable Auto-Reconnect The Enable Auto-Reconnect option allows the portal to automatically reconnect to the last connected host when the session is closed.