Lexmark E330 Service Manual - Page 130
Fuser power cable removal, Fuser removal
View all Lexmark E330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
4505 Fuser power cable removal (See "Electronics" on page 7-4.) 1.Remove the LVPS/HVPS card. See "LVPS / HVPS card assembly removal" on page 4-10 for more information. Note: The cable can be reached without fully removing the card. 2. Remove the rear cover. See "Rear cover removal" on page 4-3 for more information. 3. Remove the exit guide assembly. See "Paper exit guide assembly removal" on page 4-12 for more information. 4. Remove the two screws (one on each side) from the lower corners of the fuser. 5. Slide the fuser out far enough to expose and disconnect the AC cable connections. 6. Extract the fuser power cable. Fuser removal (See "Electronics" on page 7-4.) 1. Remove the paper exit guide assembly. See "Paper exit guide assembly removal" on page 4-12 for more information. 2. Remove the two screws (one on each side) from the lower corners of the fuser. 3. Remove the controller card cover (two screws). 4. Disconnect the thermistor at J15 and exit sensor at J10 on the controller card. 5. Slide the fuser out far enough to expose and disconnect the AC cable connections. 6. Carefully extract the fuser with thermistor and sensor cables. 4-8 Service Manual