Lexmark E330 Service Manual - Page 135
Toner level sensor removal, Transfer roll removal
View all Lexmark E330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
4505 Toner level sensor removal (See "Electronics" on page 7-4.) 1. Open the right side cover. See "Right side cover removal" on page 4-3 for more information. 2. Unplug the cable from the sensor. 3. Unsnap the toner level sensor from the frame and remove through the inside of the printer. Transfer roll removal (See "Frame" on page 7-6.) 1. Open the access cover. 2. At the right side of the transfer roll, squeeze the holder arms with the left hand while lifting with the right. Stop when the holder is unlatched. 3. At the left side of the transfer roll, squeeze the holder arms with the right hand while lifting with the left hand. Stop when the left holder is unlatched. 4. With a hand at each end, lift the transfer roll out. The springs should remain in place. Re-installation note: Verify the springs are inserted into the bearings when re-installing. Repair information 4-13