Lexmark MS711 User's Guide - Page 191
Replace roller kit [81.xx], Replace unsupported cartridge [32.xy], Replace wiper, Restore held jobs?
View all Lexmark MS711 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 191 highlights
Troubleshooting 191 Replace roller kit [81.xx] 1 Replace the roller kit. For more information, see the instruction sheet that came with the part. 2 Press to clear the message and continue printing. Replace unsupported cartridge [32.xy] Remove the toner cartridge, and then install a supported one to clear the message and continue printing. For more information, see the instruction sheet that came with the supply or see the "Replacing supplies" section of the User's Guide. Note: If you do not have a replacement cartridge, then see the "Ordering supplies" section of the User's Guide or visit www.lexmark.com. Replace unsupported fuser [32.xy] Remove the fuser, and then install a supported one. For more information, see the instruction sheet that came with the part. Replace unsupported imaging unit [32.xy] Remove the imaging unit, and then install a supported one to clear the message and continue printing. For more information, see the instruction sheet that came with the supply or see the "Replacing supplies" section of the User's Guide. Note: If you do not have a replacement imaging unit, then see the "Ordering supplies" section of the User's Guide or visit www.lexmark.com. Replace wiper 1 Replace the fuser wiper. For more information, see the instruction sheet that came with the part. 2 Press to clear the message and continue printing. Restore held jobs? Do either of the following: • Select Restore on the printer control panel to restore all held jobs stored in the printer hard disk. • Select Do not restore if you do not want any print jobs to be restored. Serial port [x] disabled [56] Try one or more of the following: • From the printer control panel, select Continue to clear the message. The printer discards any data received through the specified serial port. • Select Reset active bin to reset the active bin for a linked set of bins.