Lexmark MS711 User's Guide - Page 192
Some held jobs were not restored, Standard network software error [54]
View all Lexmark MS711 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 192 highlights
Troubleshooting 192 • Make sure the Serial Buffer menu is set to Enabled. Some held jobs were not restored From the printer control panel, select Continue to clear the message and continue printing. Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible. Standard network software error [54] Try one or more of the following: • From the printer control panel, press to confirm. • Unplug the router, then wait for 30 seconds, and then plug it back again. • Turn off the printer, and then turn it back on. • Update the network firmware in the printer or print server. For more information, contact customer support. Standard USB port disabled [56] Try one or more of the following: • From the printer control panel, press to clear the message and continue printing. Note: The printer discards any data received through the USB port. • From the printer control panel, set USB Buffer to Auto. Supply needed to complete job Try one or more of the following: • From the printer control panel, select Prompt for supplies to view all error messages that indicate what supplies are needed to continue processing the current job, and then press to clear the message and continue printing. 1 Order the missing supply immediately. 2 Install the supply. For more information, see the instruction sheet that came with the supply. • Cancel the print job, then install the missing supply, and then resend the print job. Too many bins attached [58] 1 Turn off the printer. 2 Unplug the power cord from the electrical outlet. 3 Remove the extra bins. 4 Connect the power cord to a properly grounded electrical outlet. 5 Turn the printer back on.