Onkyo TX-NR709 Owner Manual - Page 40

Using the Home Menu The Home menu provides you quick access to frequently used menus without having to go through the long standard menu. This menu enables you to change settings and view the current information. The on-screen menus appear only on a TV that is connected to the HDMI OUT MAIN. If your TV is connected to other video outputs, use the AV receiver's display when changing settings. 1 Press RECEIVER followed by HOME. The Home menu will be superimposed on the TV screen. 2 Use R/X and ENTER to make the desired selection. ■ Input*1 `You can select the input source while viewing the information as follows: the name of input selectors, input assignments, radio information, and ARC function setting. Press ENTER to display the current input source, followed by R/X to select the desired input source. Pressing ENTER again switches to the selected input source. ■ Audio `You can change the following settings: "Bass", "Treble", "Subwoofer Level", "Center Level", "Dolby Volume", "Audyssey", "Dynamic EQ", "Dynamic Volume", "Late Night", "Music Optimizer", "Re-EQ" and "Re-EQ(THX)". See also: • "Audyssey" (➔ page 52) • "Using the Audio Settings" (➔ page 61) ■ Video `You can change the following settings: "Wide Mode" and "Picture Mode*2". See also: • "Picture Adjust" (➔ page 54) ■ Info*3 `You can view the information of the following items: "Audio", "Video" and "Tuner". ■ Listening Mode `You can select the listening modes that are grouped in the following categories: MOVIE/TV, MUSIC, GAME and THX. Use R/X to select the category and F/S to select the listening mode. Press ENTER to switch to the selected listening mode. Note *1 For the PORT input selector, the name of Universal Port Option Dock will be displayed. *2 Only when you have selected "Custom" in the "Picture Mode" (➔ page 54), pressing ENTER allows you to adjust the following items via the Home menu: "Brightness", "Contrast", "Hue" and "Saturation". Press RETURN to return to the "Picture Mode" setting. *3 Depending on the input source and listening mode, not all channels shown here output the sound. Using the Sleep Timer With the sleep timer, you can set the AV receiver to turn off automatically after a specified period. 1 Press RECEIVER followed by SLEEP repeatedly to select the required sleep time. The sleep time can be set from 90 to 10 minutes in 10 minute steps. The SLEEP indicator lights on the display when the sleep timer has been set. The specified sleep time appears on the display for about 5 seconds, then the previous display reappears. Tip • If you need to cancel the sleep timer, press SLEEP repeatedly until the SLEEP indicator goes off. • To check the time remaining until the AV receiver sleeps, press SLEEP. Note that if you press again on SLEEP as the time being displayed is equal or inferior to 10 minutes, the sleep timer will go off. Setting the Display Brightness You can adjust the brightness of the AV receiver's display. 1 Press RECEIVER followed by DIMMER repeatedly to select: • Normal + MASTER VOLUME indicator lights. • Normal + MASTER VOLUME indicator goes off. • Dim + MASTER VOLUME indicator goes off. • Dimmer + MASTER VOLUME indicator goes off. Tip • (North American and Taiwan models) Alternatively, you can use the AV receiver's DIMMER. En 40