Onkyo TX-NR709 Owner Manual - Page 41

Displaying Source Information You can display various information about the current input source as follows. (Components connected to the UNIVERSAL PORT jack are excluded.) 1 Press RECEIVER followed by DISPLAY repeatedly to cycle through the available information. The following information can typically be displayed. Input source Listening mode Selecting Speaker Layout You can set which speakers you want to use by priority. 1 Press RECEIVER followed by SP LAYOUT repeatedly to select: `Speaker Layout:FH: The sound from front high speakers is output by priority. `Speaker Layout:FW: The sound from front wide speakers is output by priority. `Speaker Layout:SB: The sound from surround back speakers is output by priority. Signal format*1 Sampling frequency Input signal resolution Output resolution Tip • Alternatively, you can use the AV receiver's DISPLAY. *1 If the input signal is analog, "Analog" is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format is displayed. Information is displayed for about three seconds, then the previously displayed information reappears. Changing the Input Display When you connect an V-capable Onkyo component, you must configure the input display so that V can work properly. This setting can be done only from the front panel. 1 Press TV/CD, GAME or VCR/DVR. "TV/CD", "GAME" or "VCR/DVR" appears on the display. 2 Press and hold down TV/CD, GAME or VCR/DVR (about 3 seconds) to change the input display. Repeat this step to select the desired input display. ■ TV/CD: → TV/CD → DOCK TAPE → ■ GAME: GAME ↔ DOCK ■ VCR/DVR: VCR/DVR ↔ DOCK Note • If the "Speakers Type(Front)" setting is set to "Bi-Amp" (➔ page 46), or the "Powered Zone 2" is set to "Yes" (➔ page 46), this setting cannot be selected. • Playback conditions may be limited depending on the settings in "Speaker Settings" (➔ page 46) and "Speaker Configuration" (➔ page 47). • When a listening mode which doesn't support front high, front wide or surround back speakers is used, this setting cannot be selected. Muting the AV Receiver You can temporarily mute the output of the AV receiver. 1 Press RECEIVER followed by MUTING. The output is muted and the MUTING indicator flashes on the display. Tip • To unmute, press MUTING again or adjust the volume. • Muting is automatically cancelled when the AV receiver is set to standby. Using Headphones 1 Connect a pair of stereo headphones with a standard plug (1/4 inch or 6.3 mm) to the PHONES jack. Note • Always turn down the volume before connecting your headphones. • While the headphones plug is inserted in the PHONES jack, the speakers are turned off. (The Powered Zone 2 speakers are not turned off.) • When you connect a pair of headphones, the listening mode is set to Stereo, unless it's already set to Stereo, Mono, Direct, or Pure Audio. • If you connect an iPod or iPhone to the USB port on this device, no sound will be output from the headphones jack. Note • DOCK can be selected for the TV/CD, GAME or VCR/DVR input selector, but not at the same time. • Enter the appropriate remote control code before using the En remote controller for the first time (➔ page 69). 41