Onkyo TX-NR709 Owner Manual - Page 61
Remote Controller Setup, Lock Setup, Using the Audio Settings, Remote Mode Setup
View all Onkyo TX-NR709 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Remote Controller Setup Main menu Remote Controller Setup Remote Mode Setup See "Looking up for Remote Control Code" (➔ page 69). Lock Setup With this preference, you can protect your settings by locking the setup menus. Main menu Lock Setup ■ Setup ` Locked ` Unlocked When "Locked" is selected, the setup menus will be locked and you cannot change any setting. Using the Audio Settings You can change various audio settings from the Home menu (➔ page 40). 1 Press RECEIVER followed by HOME. 2 Use R/X and ENTER to select "Audio", and then use R/X/F/S to make the desired selection. Note • These settings are not available in either of the following cases: - a pair of headphones is connected. - the "Audio TV Out" setting is set to "On" (➔ page 59). - "HDMI Control(RIHD)" is set to "On" (➔ page 58) and you're listening through your TV speakers. Tone Control Settings ■ Bass `-10dB to 0dB to +10dB in 2 dB steps. You can boost or cut low-frequency sounds output from the front speakers. ■ Treble `-10dB to 0dB to +10dB in 2 dB steps. You can boost or cut high-frequency sounds output from the front speakers. You can adjust the bass and treble for the front speakers, except when the Direct, Pure Audio or THX listening mode is selected. Operating on the AV receiver 1 Press TONE repeatedly to select either "Bass" or "Treble". 2 Use + and - to adjust. Note • To bypass the bass and treble tone circuits, select the Direct, Pure Audio or THX listening mode. • This setting is not available when the multichannel Analog input is selected. Speaker Levels ■ Subwoofer Level ` -15.0dB to 0.0dB to +12.0dB in 0.5 dB steps. ■ Center Level ` -12.0dB to 0.0dB to +12.0dB in 0.5 dB steps. You can adjust the volume of each speaker while listening to an input source. These temporary adjustments are cancelled when the AV receiver is set to standby. To save the setting you made here, go to "Level Calibration" (➔ page 48) before setting the AV receiver to standby. Note • You cannot use this function while the AV receiver is muted. • Speakers that are set to "No" or "None" in "Speaker Configuration" (➔ page 47) cannot be adjusted. Dolby Volume ■ Dolby Volume See "Dolby Volume" of "Audio Adjust" (➔ page 51). Note • This setting cannot be used in either of the following cases: - Pure Audio or Direct listening mode is selected. - the multichannel analog input is selected. - any of the THX listening modes is selected, with "Loudness Plus" set to "On" or "Preserve THX Settings" set to "Yes" (➔ page 49). • When "Dolby Volume" is set to "On", the "Dynamic EQ" and "Dynamic Volume" settings of all input selectors are switched to "Off". En 61