Onkyo TX-NR709 Owner Manual - Page 64
Controlling Zone 2 Components, Adjusting the Volume for Zone 2
View all Onkyo TX-NR709 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Controlling Zone 2 Components ■ Operating on the AV receiver Input selector buttons ZONE 2 OFF MASTER VOLUME 1 To turn on Zone 2 and select an input source, press ZONE 2 followed by an input selector button within 8 seconds. Zone 2 turns on, the Z2 indicator lights on the display. Tip • The corresponding trigger output goes high (+12 V). To select AM or FM, press the TUNER input selector button repeatedly. To select the same source as the main room's, press ZONE 2 repeatedly until "Z2 Selector: Source" appears on the display. To turn off Zone 2, press OFF. The zone is turned off. Tip • The corresponding trigger output goes low (0 volts). ■ Operating on the remote controller To control Zone 2, you must press ZONE2 on the remote controller first. RECEIVER ZONE2 2 To select an input source for Zone 2, press ZONE2, followed by an input selector button. To select AM or FM, press the TUNER input selector repeatedly. Note • You cannot select different AM or FM radio stations for your main room and Zone 2. The same AM/FM radio station will be heard in each room. 3 To turn off Zone 2, press ZONE2 followed by RECEIVER. Tip • The corresponding trigger output goes low (0 volts). Adjusting the Volume for Zone 2 ■ Operating on the remote controller 1 Press ZONE2. 2 Use VOL R/X to adjust the volume. ■ Operating on the AV receiver 1 Press ZONE 2 (the Z2 indicator on the display flash). 2 Use MASTER VOLUME control within 8 seconds to adjust the volume. If your Zone 2 speakers are connected to a receiver or integrated amp in Zone 2, use its volume control to adjust the volume. Input selector buttons MUTING VOLR/X 1 Press ZONE2 and then press RECEIVER. Zone 2 turns on, the Z2 indicator lights on the display. Tip • The corresponding trigger output goes high (+12 V). En 64