Panasonic 55 Professional Display for Entry-Level Digital Signage Operating In - Page 55
Network status], DIGITAL LINK mode] LF80 series only
View all Panasonic 55 Professional Display for Entry-Level Digital Signage manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
[IP address]: (IP address display and setting) Enter an IP address when DHCP server is not used. [Subnet mask]: (Subnet mask display and setting) Enter a Subnet mask when DHCP server is not used. [Gateway]: (Gateway address display and setting) Enter a gateway address when DHCP server is not used. Note ● When [DHCP] is set to [On], the IP address, etc. will be displayed in grey. Entering numbers IP address I192.168. 0. 8 1. Select the address and press . 2. Select digits with . 3. Change numbers with . 4. Press . You can cancel the change by pressing . Select [Save] and press . Save the current network Setup. Note ● To use a DHCP server, make sure the DHCP server is started. ● Contact your network administrator for details on [IP address], [Subnet mask] and [Gateway]. ● Shipping condition [DHCP]: Off [IP address]: 192.168.0.8 [Subnet mask]: 255.255.255.0 [Gateway]: 192.168.0.1 [Port] Set the port number used for command control. Select [Port] and press to set the number. ● The available setting range is 1024 - 65535. ● Entering numbers (see page 55) Note ● When the PJLink protocol is used, the port setting is not necessary. [MAC address] Displays the MAC address of this unit. ■■[Network status] Checks the current Network settings status. Network status DHCP IP address Subnet mask Gateway MAC address Off 192. 168. 0. 8 255. 255. 255. 0 192. 168. 0. 1 12:34:56:78:9A:BC ■■[DIGITAL LINK mode] (LF80 series only) Switches communication method of DIGITAL LINK terminal. [Auto]: Communication method is selected automatically. [DIGITAL LINK]: Communication method is fixed to DIGITAL LINK. [Ethernet]: Communication method is fixed to Ethernet. [Long reach]: Communication method is fixed to Long reach. Modes allowing communication : Valid ― : Invalid Settings Auto For DIGITAL LINK For Long reach Communication validity Picture transmission Ethernet 100 m 150 m RS232C ― ― For Ethernet ― ― ― DIGITAL LINK ― Long reach ― Ethernet ―― ― Note ● When connected with the [Long reach] communication method, the maximum transmission distance is 150 m. In this case, this unit can receive the signals of up to 1080/60p (148.5 MHz). ● If the communication method of the twisted pair cable transmitter is set to [Long reach], set [DIGITAL LINK mode] to [Auto]. Then, connection is enabled with the [Long reach] communication method. When connecting with the separately sold DIGITAL LINK Switcher (ET-YFB200G) with the [Long reach] communication method, set [DIGITAL LINK mode] to [Long reach]. English 55