Pfaff creative vision Owner's Manual - Page 119

Orbiting - to check corners Orbiting can be used to trace the design field by touching each of the four corner icons. You can find the center of the design again by touching the centering icon. The orbit function will also swiftly move the crosshair to the selected position when doing precise positioning. Use the corner icons to set the connecting point for precise positioning in a corner of the design. This is the easiest and most precise way since the connecting point will be automatically placed exactly in the corner. This is useful when positioning a design on a patterned fabric. The orbiting icons may be used when either locking point or matching point is selected. When touching an orbiting icon, the selected point will automatically be set to the corresponding orbiting position, i.e. at a corner or at the center of the embroidery. E.g. when choosing the upper left orbiting icon, the connecting point will be set at the upper left corner in the outer line of the designs. After this, you can continue and make your own adjustments on the connecting point. Zoom to needle (J) Precise positioning is easy to use with the new zoom to needle option. Touch the zoom to needle icon (J) to pan to the current needle position and J zoom in as much as possible on the screen. You can position the locking and matching point exactly where you want them. Embroidery mode - stitch-out Disable needle warning (K) Check allow lower needle icon (K) to temporarily allow the needle to be in a lower position while moving the hoop. The needle can then remain close to the fabric when using precise positioning. Just make sure the needle is above the fabric to prevent damage to the needle and fabric. Note: The warning cannot be disabled when the needle is K below the stitch plate. 9:9