Philips 46PFL5706/F7 User Manual - Page 42

English Français Español Connecting the TV to the internet using an Ethernet cable Connecting a digital home theater amplifier using a digital audio coaxial cable Ethernet cable LAN WAN 1 2 3 4 5 hub or broadband router internet LAN telecommunications Ethernet cable equipment (modem, etc.) Note • Please purchase shielded Ethernet cables at your local store and use them when you connect to network equipment. • After connecting an Ethernet cable, set up necessary network settings. (For the network setup, refer to 'Network' on page 30.) • Do not insert any cable other than an Ethernet cable to the Ethernet port to avoid damaging the unit. • If your telecommunications equipment (modem, etc.) does not have broadband router functions, connect a broadband router. • If your telecommunications equipment (modem, etc.) has broadband router functions but there is no vacant port, use a hub. • For a broadband router, use a router which supports 10BASE-T / 100BASE-TX. • Do not connect your PC directly to the Ethernet port of this unit. Connecting the TV to the internet using a wireless LAN Wireless LAN Access Point (AP) (e.g. wireless router) WAN OUT DIGITAL AUDIO IN digital home theater amplifier Note • Due to Copyright restrictions, the broadcaster may choose to mute PCM audio over Digital Audio Output for certain channels, shows or segments during the broadcast. internet LAN network equipment (modem, etc.) Ethernet cable Note • After you made the wireless connection, set up necessary network settings. (For the network setup, refer to 'Network' on page 30.) • Use a Wireless LAN Access Point (AP) (e.g. wireless router) which supports IEEE 802.11 b/g/n. (n is recommended for stable operation of the wireless network.) • This unit does not support Ad-hoc mode. • Other radio devices or obstacles may cause interference to the wireless network connection. EN 41