Pioneer BDP-150 Operating Instructions - Page 48

08 Problem Check Software updating is slow. Remedy Depending on the Internet connection and other conditions, some time may be required to update the software. A message other than "Networks is OK." is displayed when Connection Test is performed. Is "Network is FAILED." displayed? • Check that this player and the Ethernet hub (or router with a hub functionality) are properly connected. • If the IP address is obtained using the DHCP server function, check the setting is correct at the Information (page 35). For details on the DHCP server function, see the operating instructions for the Ethernet hub (or router with a hub functionality). • Set the IP address manually. • Check the operation and settings of the DHCP server function of the Ethernet hub (or router with hub functionality). For details on the DHCP server function, see the operating instructions for the Ethernet hub (or router with a hub functionality). • If this player has been set manually, reset the IP address of this player or other components. Is the Ethernet hub (or router • Check the settings and operation the Ethernet hub (or router with a with a hub functionality) hub functionality). For details, see the operating instructions for the operating properly? Ethernet hub. • Reboot the Ethernet hub (or router with a hub functionality). Others Problem Check Remedy Power does not turn on. Is the power cord properly connected? • Plug the power cord securely into the power outlet (page 18). • Unplug the power cord, wait several seconds, then plug the power cord back in. The player's power turns off Is Auto Power Off set to 10 If Auto Power Off is set to 10 min/20 min/30 min, the player's power automatically. min/20 min/30 min? turns off automatically if no operation is performed for over 30 minutes (page 37). The player's power turns on Is Control set to On? automatically. The player's power may turn on together with the power of the TV connected to the HDMI OUT terminal. If you do not want the player's power to turn on when the TV's power is turned on, set Control to Off (page 35). This unit cannot be operated. • Use within the specified usage temperature range (page 51). • If the power cannot be turned off (set to standby), use a thin rod to press the reset button on the main unit's front panel. The unit restarts, at which point it is again operable. The player cannot be operated with the remote control. Are you operating the remote Operate from within 7 m of the remote control sensor. control from a point too far away from the player? Are the batteries dead? Replace the batteries (page 5). Input of the connected TV and AV system switches automatically. Is Control set to On? The input of the TV and AV system (AV receiver or amplifier, etc.) connected to the HDMI OUT terminal may automatically switch to the player when playback starts on the player or the menu screen (Home Media Gallery, etc.) is displayed. If you do not want the inputs of the connected TV and AV system (AV receiver or amplifier, etc.) to switch automatically, set Control to Off (page 35). Settings I have made have been cleared. • Have you disconnected the Always press  STANDBY/ON on the player's front panel or power cord while the player's  STANDBY/ON on the remote control and check that POWER OFF power was on? has turned off from the player's front panel display before • Has there been a power failure? disconnecting the power cord. Be particularly careful when the power cord is connected to the AC outlet on another device because the player turns off in conjunction with the device. 48 En