Pioneer SC-67 Owner's Manual - Page 35

03 Connecting your equipment Connecting other audio components This receiver has both digital and analog inputs, allowing you to connect audio components for playback. When you set up the receiver you'll need to tell the receiver which input you connected the component to (see also The Input Setup menu on page 47). Turntable CD player, MD, DAT, etc. Select one AUDIO OUT DIGITAL OUT R ANALOG L COAXIAL OPTICAL DIGITAL IN OPTICAL IN 1 (DVD) BD IN IN 1 (DVD) BD IN IN 2 (SAT/CBL) IN 3 (DVR/BDR) IN 4 IN 6 (VIDEO) MONITOR OUT PHONO IN IN 1 (CD) IN 7 OUT 2 OUT 1 LAN(10/100) DC OUTPUT for WIRELESS LAN (CONTROL) (OUTPUT 5 V 0.6 A MAX) COAXIAL ASSIGNABLE OPTICAL ASSIGNABLE ADAPTER PORT IN 1 IN 2 IN 1 IN 2 (DVD) (SAT/CBL) (TV) (DVR/BDR) OUT (OUTPUT 5 V 0.1 A MAX) SIGNAL GND ASSIGNABLE IN 2 (SAT/CBL) IN 3 (DVR/BDR) IN 4 IN 6 (VIDEO) MONITOR OUT PHONO IN IN 1 (CD) IN 7 OUT 2 OUT 1 LAN(10/100) DC OUTPUT for WIRELESS LAN (CONTROL) (OUTPUT 5 V 0.6 A MAX) COAXIAL ASSIGNABLE OPTICAL ASSIGNABLE ADAPTER PORT IN 1 IN 2 IN 1 IN 2 (DVD) (SAT/CBL) (TV) (DVR/BDR) OUT (OUTPUT 5 V 0.1 A MAX) SIGNAL GND ASSIGNABLE ! If your turntable has line-level outputs (i.e., it has a built-in phono pre-amp), connect it to the ANALOG IN 1 (CD) inputs instead. ! You can't hear HDMI audio through this receiver's digital out jack. Connecting additional amplifiers This receiver has more than enough power for any home use, but it's possible to add additional amplifiers to every channel of your system using the pre-outs. Make the connections shown below to add amplifiers to power your speakers. FRONT 1 SUBWOOFER 2 SURROUND SURR BACK F HEIGHT (Single) F WIDE L CENTER R PRE OUT FRONT 1 SUBWOOFER 2 SURROUND SURR BACK F HEIGHT (Single) F WIDE L CENTER R PRE OUT ANALOG INPUT L R ANALOG INPUT ANALOG INPUT L R ANALOG INPUT L R ANALOG INPUT L R ANALOG INPUT L R ANALOG INPUT Front channel amplifier Center channel amplifier (mono) Surround channel amplifier Front height channel amplifier Front wide channel amplifier Surround back channel amplifier Powered subwoofer 2 ANALOG INPUT Powered subwoofer 1 ! If you're not using a subwoofer, change the front speaker setting (see Speaker Setting on page 95) to LARGE. ! You can use the additional amplifier on the surround back channel pre-outs for a single speaker as well. In this case plug the amplifier into the left (SURROUND BACK L (Single)) terminal only. ! The sound from the surround back terminals will depend on how you have configured the Speaker system set- ting on page 98. ! If you have two subwoofers, the second subwoofer can be connected to the SUBWOOFER 2 terminal. Connecting two subwoofers increases the bass sound to achieve more powerful sound reproduction. In this case, the same sound is output from the two subwoofers. ! To hear sound only from the pre-outs, switch the speaker terminals to SP: OFF (page 78) or simply disconnect any speakers that are connected directly to the receiver. It is also possible to hear sound only from the pre-outs by switching the AMP setting to OFF and setting the pre-amp mode to turn the power amplifiers for all channels off (see Setting the Audio options on page 74). 35