Ricoh Aficio MP C3500 General Settings Guide - Page 70

System Settings ❖ Ethernet Speed Set the access speed for networks. Select a speed that matches your network environment. [Auto Select] should usually be selected. • Auto Select • 10Mbps Full Duplex 2 • 10Mbps Half Duplex • 100Mbps Full Duplex • 10Mbps Half Duplex ❖ LAN Type When you have installed the IEEE 802.11b interface unit, select the method of connection. • Ethernet • IEEE 802.11b [LAN Type] is displayed when wireless LAN board is installed. If Ethernet and IEEE 802.11b (wireless LAN) are both connected, the selected interface has priority. ❖ Ping Command Check the network connection with ping command using given IPv4 address. If you fail to connect to the network, check the following, and then retry the ping command. • Make sure that "IPv4" in [Effective Protocol] is set to "Effective". • Check that the machine with assigned IPv4 address is connected to the network. • There is a possibility that the same IPv4 address is used for the specified equipment. ❖ Permit SNMPv3 Communication Set the encrypted communication of SNMPv3. • Encryption Only • Encryption / Clear Text If you select to [Encryption Only], you need to set an encryption password for the machine. ❖ Permit SSL/TLS Communication Set the encrypted communication of SSL/TLS. • Ciphertext Only • Ciphertext Priority • Ciphertext / Clear Text If you set to [Ciphertext Only], you need to install the SSL certificate for the machine. 62