Samsung MultiXpress SCX-8238 User Guide - Page 35

media and tray 2. This chapter provides information on how to load originals and print media into your machine. This chapter includes: • Loading originals • Selecting print media • Loading paper in the tray • Printing on special media • Tray setting Loading originals You can use the scanner glass or the duplex automatic document feeder (DADF) to load an original for copying, scanning, and sending a fax. On the scanner glass Make sure that no originals are in the DADF. If an original is detected in the DADF, the machine gives it priority over the original on the scanner glass. To get the best scan quality, especially for colored or gray-scaled images, use the scanner glass. Preparing originals • Do not load paper smaller than 25 x 25 (1.0 x 1.0 inches) or larger than 297 x 432 mm (11.7 x 17 inches). • Make sure any glue, ink, or correction fluid on the paper is completely dry before loading. 1. Open the DADF. 2. Place the original face down on the scanner glass and align it with the registration guide at the top left corner of the glass. 3. Close the DADF. • Leaving the DADF open while copying may affect copy quality and toner consumption. • Dust on the scanner glass may cause black spots on the printout. Always keep it clean. • If you are copying a page from a book or magazine, lift the DADF until its hinges are caught by the stopper and then close the lid. If the book or magazine is thicker than 30 mm (1 inch), start copying with the lid open. • Be careful not to break the scanner glass. You may get hurt. • Do not put hands on the scanner glass while closing the DADF. The DADF may fall on your hands and cause injury. • Do not look at the light inside of the scanner while copying or scanning. It is harmful to eyes. Media and tray_ 35