Schwinn 510e Elliptical Service Manual - Page 11
Condition/Problem, Things to Check, Solution
View all Schwinn 510e Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Condition/Problem Resistance does not change (machine turns on and operates) Console shuts off (enters sleep mode) while in use Unit rocks/does not sit level Foot pedals loose/unit difficult to operate Drive train click/tick noise once per full crank revolution Knocking sound during machine operation Things to Check Check Console Check data cable integrity Check data cable connections/orientation Check Servo Motor (requires shroud removal) Check electrical (wall) outlet Check connection at front of unit Check data cable integrity Check data cable connections/orientation Reset machine Check magnet position (requires shroud removal) Check Speed Sensor (requires shroud removal) Check leveler adjustment Check surface under unit Hardware Check crank/pulley assembly Check foot assemblies, leg assemblies, handlebar assemblies Check for loose hardware Check hardware at junction between Lower Handlebar Arms, Pedals, and Legs Solution Check for visual sign that Console is damaged. Replace Console if damaged. All wires in cable should be intact. If any are visibly crimped or cut, replace cable. Be sure cable is connected securely and oriented properly. Reseat all connections. Small latch on connector should line up and snap into place. If magnets move, adjust until they are within the proper range. Replace Servo Motor if not functioning properly. If the above steps do not resolve the problem, contact Customer Service (if inside US/Canada) or your local distributor (if outside US/Canada) for further assistance. Make sure unit is plugged into a functioning wall outlet. Connection should be secure and undamaged. Replace adapter or connection at unit if either are damaged. All wires in the cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. Magnet should be in place on pulley. Speed sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. Adjust levelers until machine is level. Adjustment may not be able to compensate for extremely uneven surfaces. Move machine to level area. Tightly secure all hardware on the Pedal Arms and Handlebar Arms. Disconnect left and right foot assemblies and rotate crank. If sound persists, replace crank/pulley assembly. If sound does not come from rotating crank, check foot assemblies and upper/lower handlebars. Manually move foot, leg, and handlebar assemblies to isolate sound. Replace part making sound. Tightly secure all hardware on the Stabilizers and the base of the Console Mast. Make sure that the hardware is clear of any debris. 11