Schwinn 510e Elliptical Service Manual - Page 17

Drive Belt. The Crank Arms and Flywheel should move as one.

Get Schwinn 510e Elliptical PDF manuals and user guides View all Schwinn 510e Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

10. Using a 6mm hex wrench, loosen the Tensioner Hardware. 11. Adjust the Tensioner Nut on the Tensioner Bolt using a 10mm open end wrench. Drive Pulley 12. When the tension is correct, tighten the Tensioner Hardware to hold the Tensioner Bracket in position. 13. Carefully turn the Right Crank Arm and check the movement of the Drive Belt. The Crank Arms and Flywheel should move as one. ! Be sure to keep fingers clear of all pinch hazards when you turn the Right Crank Arm. Adjust the belt tension again if necessary. Tensioner Hardware Tensioner Bolt Tensioner Nut Tensioner Bracket 14. Re-assemble the machine in the reverse order of when the parts were removed. 15. Final Inspection Inspect your machine to ensure that all hardware is tight and components are properly assembled. Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's Manual. Frame Bracket Drive Belt 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
17
10. Using a 6mm hex wrench, loosen the Tensioner Hardware.
11. Adjust the Tensioner Nut on the Tensioner Bolt using a 10mm open
end wrench.
12. When the tension is correct, tighten the Tensioner Hardware to hold
the Tensioner Bracket in position.
13. Carefully turn the Right Crank Arm and check the movement of the
Drive Belt. The Crank Arms and Flywheel should move as one.
!
Be sure to keep fingers clear of all pinch hazards when you
turn the Right Crank Arm.
Adjust the belt tension again if necessary.
14. Re-assemble the machine in the reverse order of when the parts
were removed.
15. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
Drive Pulley
Drive Belt
Tensioner
Hardware
Tensioner
Bolt
Frame Bracket
Tensioner Nut
Tensioner
Bracket