Schwinn 510e Elliptical Service Manual - Page 20
Remove the Left Upper Engine Shroud.
View all Schwinn 510e Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
6. Using a #2 Phillips screwdriver, remove the indicated screws (by ovals) from the Left Upper Engine Shroud. Note: T he Power Inlet is attached to the inside of the Left Upper Engine Shroud. Do not crimp the Power Inlet Cable. 7. Remove the Left Upper Engine Shroud. 8. Using a #2 Phillips screwdriver, remove the 4 screws that attach each of the Lower Engine Shrouds, and remove them. Left Upper Engine Shroud Power Inlet Lower Engine Shroud, Left 9. Insert 2.5" x 10" cardboard between the Brake Magnet and the Flywheel, and tape the cardboard to the Brake Magnet. Note: Be sure the cardboard covers all of the Brake Magnet. The cardboard will keep the Brake Magnet from grabbing onto the Flywheel. 10. Using two 8mm open faced wrenches, loosen both of the securing nuts (indicated by arrow) that secure the Brake Cable to the Brake Arm. 11. Adjust the two securing nuts (indicated by arrows) to shift the Brake Cable until the closest point of the Brake Magnet is within 3.0mm (1/8") of the Flywheel. Tighten the securing nuts. Note: If the cardboard is not 3mm (1/8") thick, you can use the pages of a paperback book to measure the gap. Approximately 36 pages (sheets) = 3mm. Brake Cable Brake Magnet Arm Tension Spring Brake Arm Flywheel 20