Sharp XE A302 XE-A302 Operation Manual in English and Spanish - Page 62

READING (X) AND RESETTING (Z) OF SALES TOTALS • Use the reading function (X) when you need to take a reading of sales information entered since the last reset. You can take this reading any number of times. It does not affect the register's memory. • Use the resetting function (Z) when you need to clear the register's memory. Resetting prints all sales information and clears the entire memory except for the GT1 through GT3, Training GT, reset count, and consecutive number. 1 Summary of Reading (X) and Resetting (Z) Reports X1 and Z1 reports: Daily sales reports X2 and Z2 reports: Periodic (monthly) consolidation reports When you take an X or Z report, turn the mode switch to the appropriate position referring to the column of "Mode switch position" shown on the table below, and use the following corresponding key sequence. Item Flash report: (Only display) To clear the display, press the l key or turn the mode switch to another position. Mode switch position OPX/Z X1/Z1 X2/Z2 X -- -- Key operation Dept. code d : Department sales total ! ( For dept. 1 to 6 : Dept. key ( to ) @ key: Amount of cash in drawer A key: Sales total Full sales report A -- X1, Z1 X2, Z2 Reading: P Resetting: A Department report -- d X1 X2 Reading: Individual group total report on department Full group total report on department PLU report by designated range PLU report by associated department Transaction report -- X1 X2 Reading: Group number @ d -- X1 X2 0 Reading: @d All PLUs Reading: Start PLU code @ End PLU code p -- X1, Z1 X2, Z2 Resetting: All PLUs Start PLU code @ End PLU code Pp -- X1 X2 Reading: Associated dept. code d p -- X1 X2 1 Reading: A 60