Sony HDWM2100/20 Operation Manual - Page 30
Cassettes, 3-4-1 Cassette Types, 3-4-2 Inserting and Ejecting Cassettes, Inserting and Ejecting
View all Sony HDWM2100/20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Chapter 3 Preparations 3-4 Cassettes 3-4-1 Cassette Types This unit uses the following HDCAM cassettes for playback. HDCAM cassettes Small cassettes BCT-6HD/12HD/22HD/32HD/40HD Large cassettes BCT-34HDL/64HDL/94HDL/124HDL The unit can also play back the following cassettes. • Digital Betacam cassettes • MPEG IMX cassettes • Betacam SX cassettes • Betacam SP cassettes (metal tape) • Betacam cassettes (oxide tape) 2 Check the following points, then insert the cassette in the orientation shown in the figure. • Check that message "ERR-10" is not shown in the time data/menu display section. • Check that there is no slack in the tape. The cassette is drawn into the unit, and the STANDBY and STOP buttons light. If message "ERR-10" appears in the time data/menu display section, there is moisture condensation in the unit. Removing slack from the tape Press in one of the reels with a finger, and turn gently in the direction shown by the arrows until there is no slack in the tape. 3-4-2 Inserting and Ejecting Cassettes It is not possible to insert or eject a cassette unless the unit is powered on. Inserting a cassette EJECT button 1 2 Small cassette PREROLL STANDBY REW PLAY F FWD STOP Large cassette STANDBY button STOP button Ejecting a cassette Press the EJECT button. Note Ejecting is a local operation. It is not possible to eject a cassette in another unit by remote control. If the tape slacks inside the unit, pressing the EJECT button may not eject the cassette. For information about how to remove the cassette in such a case, refer to the Installation Manual. 1 Turn the POWER switch on. 3-6 Chapter 3 Preparations