Sony LF-B1 Operating Instructions (LF-PK1) - Page 10

Base Station Preparations Connecting the IR Blaster Attach the supplied IR Blaster to the device connected to the base station. You can control the device with the LocationFree TV's on-screen remote control via the IR Blaster. When operating two devices with the IR Blaster, set the devices and the IR Blaster as shown. IR Blaster to IR BLASTER port IR Blaster Infrared transmitter Infrared receiver With reference to the operating instructions of the device, make sure to place the IR Blaster just above the infrared receiver. Note Do not remove the backing paper from the IR Blaster yet. After configuring LocationFree Player remote control settings (1 page 30), remove the backing paper from the IR Blaster and fix it in place. Infrared receivers Note For details on setting up a device, refer to the operating instructions of the device. If the infrared receivers on the two devices do not line up like the picture above, you cannot control them with the single supplied IR Blaster, and you need to purchase a plug adapter (PC-230M, not supplied) and another IR Blaster. Connect the plug adapter to the IR BLASTER port on the base station and connect each IR Blaster to a port on the adapter plug. z Tips • If the IR Blaster cable is too short, use the extension cable (RK-G138, not supplied). • Infrared receivers on Sony VCRs and other products are identified with the symbol. • You can set up two on-screen remote controls for each video input connector. These on-screen remote controls allow you to operate two devices connected directly to the base station, and to control video input via those devices. 10