Sony LF-B1 Operating Instructions (LF-PK1) - Page 20
If NetAV Check is incomplete, setup types: [Easy Setup] and [Advanced Setup].
View all Sony LF-B1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
7 Read the "Dynamic DNS Terms-of-Use Agreement" included in the box and then click [Agree]. 9 Click [Check]. Setup and Connections When you click [Agree], the information required for the dynamic DNS is saved to the base station. 8 Follow the on-screen instructions to wait until the NETAV LED stops blinking (umber) and click [Next] when the NETAV LED turns off. The setup is complete if [Success] appears in the [NetAV Check] page. If the test page does not appear, check the network connection. 10 Click [Exit Setup]. Restart the base station. Close the browser. z Tips • The NETAV LED continues to blink for about one minute before turning off. • If the NETAV LED turns on umber, check that the router and modem are turned on and the LAN cable is connected properly. • When the NETAV LED turns green, another device is connected by NetAV. Wait until the LED turns umber to perform this step. • NetAV cannot be used via a proxy server. If NetAV Check is incomplete Read the instructions on the NetAV Check page and configure the necessary settings. The base station needs to be set up to use the NetAV function away from home. There are two setup types: [Easy Setup] and [Advanced Setup]. [Easy Setup] requires the router to be UPnP compatible and the UPnP function of the router to be enabled. Refer to the operating instructions for your router and confirm the settings. If your router is not UPnP compatible, you prefer not to use the UPnP function of the router, or if you use the UPnP function but the setup is unsuccessful, port forwarding needs to be set on the router. z Tips • Setting port forwarding on the router requires a static IP address to be set in the [Internet Connection] frame of the [Advanced Setup] page for the base station. For details, refer to the instruction 20