Sony STRDA3500ES Operating Instructions - Page 139
Tuner, Audio Control function.
UPC - 027242754355
View all Sony STRDA3500ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
The Control for HDMI function does not work. • Check the HDMI connection (page 85). • Make sure "Control for HDMI" is set to "ON" in the HDMI settings menu. • Make sure the connected component is compatible with the Control for HDMI function. • Check the Control for HDMI settings on the connected component. Refer to the operating instructions of the connected component. • If you change the HDMI connection, connect/disconnect the AC power cord, or there is a power failure, repeat the procedures of "Preparing Control for HDMI function" (page 86). No sound is output from the receiver and TV speaker while using the System Audio Control function. • Make sure the TV is compatible with the System Audio Control function. • If the TV does not have System Audio Control function, set the "Audio Out" settings in HDMI settings menu to - "TV+AMP" if you want to listen to the sound from the TV speaker and receiver. - "AMP" if you want to listen to the sound from the receiver. • When you connect the receiver to a video component (projector, etc.), sound may not be output from the receiver. In this case, select "AMP". • If you cannot listen to the sound of a component connected to the receiver - Change the input of the receiver to HDMI when you want to watch a program on a component connected via HDMI connection to the receiver. - Change the TV channel when you want to watch a TV broadcast. - Select the component or input you want to watch when you watch a program on the component connected to the TV. Refer to the operating instructions of the TV on this operation. • When using the Control for HDMI function, you cannot control the connected component using TV's remote. - Depending on the connected component and TV, you may need to set up the component and TV. Refer to the operation instructions supplied with each component and TV. - Change the input of the receiver to the HDMI input connected to the component. The TV's remote commander cannot be used to control the connected component when using the Control for HDMI function. • Change the input of the receiver to the HDMI input connected to the component. Tuner The FM reception is poor. • Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna (aerial) as shown below. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe. Outdoor FM antenna (aerial) Receiver Ground (earth) wire (not supplied) To ground Additional Information continued 139US