Sony STRDA3500ES Operating Instructions - Page 46
Performing Auto Calibration, On setting up the active, subwoofer, Using the receiver as a pre
UPC - 027242754355
View all Sony STRDA3500ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
On setting up the active subwoofer • When a subwoofer is connected, turn on the subwoofer and turn up the volume beforehand. Turn the MASTER VOLUME knob to just before the mid-point. • If you connect a subwoofer with the crossover frequency function, set the value to maximum. • If you connect a subwoofer with an auto standby function, set it to off (deactivated). Note Depending on the characteristics of the subwoofer you are using, the setup distance value may be further away from the actual position. Using the receiver as a preamplifier You can use the Auto Calibration function when you use the receiver as a pre-amplifier. In this case, the distance value shown on the display may differ from the actual distance value. However, there will be no problems even if you continue to use the receiver with that value. 1 Press GUI MODE repeatedly to select "GUI ON". The GUI menu appears on the TV screen. Press MENU if the GUI menu does not appear on the TV screen. 2 Press V/v repeatedly to select "Settings", then press or b. The Settings menu list appears on the TV screen. 3 Press V/v repeatedly to select "Auto Calibration", then press or b. 4 Press V/v repeatedly to select "Quick Setup", then press . 5 Press V/v repeatedly and press to un-check the items you do not want to measure. • Speaker Distance • Speaker Level • Frequency Characteristic Performing Auto Calibration GUI MODE , V/v/B/b 6 Press b. 7 Press to select "Start". MENU 46US