Sony STRDA3500ES Operating Instructions - Page 49
Message list after Auto Calibration measurement, continued
UPC - 027242754355
View all Sony STRDA3500ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Getting Started Message list after Auto Calibration measurement Message appears in GUI menu [Display window] Explanation Error Code: 31 SPEAKERS (OFF/A/B/A+B) is set to off. Set it to others and perform the measurement [E-xxx: 31]* again. Error Code: 32 None of the speakers were detected. Make sure that the optimizer microphone is connected [E-xxx: 32]* properly and perform the measurement again. If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected. Error Code: 33 • None of the front speakers are connected or only one front speaker is connected. [E-xxx: 33]* • The optimizer microphone is not connected. • Either the left or right surround speakers is not connected. • Surround back speakers are connected even though surround speakers are not connected. Connect the surround speaker(s) to the SURROUND terminals. • The surround back speaker is connected only to the SPEAKERS SURROUND BACK R terminals. When you connect only one surround back speaker, connect it to the SPEAKERS SURROUND BACK L terminals. Warning The measurement has completed. However, the noise level is high. You may be able to Code: 40 perform the measurement properly if you try it again, even though the measurement cannot [W-xxx: 40]* be performed in all environments. Try to perform the measurement in a quiet environment. Warning The input from the microphone is too loud. Code: 41 • The distance between the speaker and the microphone may be too close with each other. [W-xxx: 41]* Retry the measurement after setting them further apart from each other. Warning • The volume may be too loud when you use the receiver as a pre-amplifier. Code: 42 [W-xxx: 42]* Warning The distance and position of a subwoofer cannot be detected. This may be caused by noise. Code: 43 Try to perform the measurement in a quiet environment. [W-xxx: 43]* NO WARNING There is no warning information. * xxx represent a speaker channel. F Front FL Front Left FR Front Right CNT Center SL Surround Left SR Surround Right SB Surround Back SBL Surround Back Left SBR Surround Back Right SW Subwoofer •Error Code: 31, 32, 33 1 Press B/b to select "Retry", then press . 2 Press to select "Start". 3 Follow the instructions from step 7 of "Performing Auto Calibration". continued 49US