Toshiba 56HM66 Owner's Manual - English - Page 18

HM66_EN.book Page 18 Thursday, February 23, 2006 2:49 PM Chapter 4: Setting up your TV 3 Open the Terrestrial menu, highlight Channel Add/ Delete, and then press T. Terrestrial Input Configuration Channel Program Channel Add/Delete Signal Meter Navigate ENTER Select CH RTN Back EXIT Exit 4 The illustration below left shows channels programmed for the ANT 1 antenna input. To view the list of channels programmed for the ANT 2 antenna input, press Bb to highlight ANT 2 and press T. Channel Add/Delete 2 2 - 1 2 - 2 3 4 5 6 7 7 - 1 8 Analog Digital Digital Analog Analog Analog Analog Analog Digital Analog ANT 1 ANT 2 Reset Cancel Done Channel Add/Delete 1 2 3 4 5 6 7 8 9 10 Analog Analog Analog Analog Analog Analog Analog Analog Analog Analog ANT 1 ANT 2 Reset Cancel Done To add a channel to the channel memory: Highlight the unchecked box next to the channel number you want to add, and then press T to check the box. To manually add digital subchannels on a physical channel: Use the Channel Numbers and the Dash (=) on the remote control to enter the channel number (for example, 56-1). If the channel is found, the number will be added to the list and the box will be checked. If the channel is not found, a message will appear. To remove a channel from the channel memory: Highlight the checked box next to the channel number you want to remove, and then press T to uncheck the box. To save your new settings: Highlight Done and press T. To revert to your original settings: Highlight Cancel and press T before saving. To remove all channels from the channel memory: Highlight Reset and press T, and then highlight Done and press T. Notes: • This action applies to the current antenna input only. To delete/add channels on the other input, highlight the input you want (ANT1, or ANT 2) and press T. • This action cannot be cancelled unless you highlight Cancel and press T before saving your changes. Channel Add/Delete 2 2 - 1 2 - 2 3 4 5 6 7 7 - 1 8 Analog Digital Digital Analog Analog Digital Analog Analog Digital Analog ANT 1 ANT 2 Reset Cancel Done Programming your favorite channels You can program up to 18 channels as favorite channels into two Favorite Channel lists (nine channels from the ANT 1 input, and nine from the ANT 2 input). You can then scan through your favorite channels only, skipping other channels you do not normally watch. To add and delete channels in the Favorite Channels lists: 1 Press Y and open the Preferences menu. 2 Highlight Favorite Channels and press T. 3 Use Bb to select either ANT 1, or ANT 2, and press T. 4 Highlight Edit and press T. Preferences Favorite Channels Closed Caption Mode Off Closed Caption Advanced Input Labeling Menu Language English Channel Browser Setup Navigate ENTER Select CH RTN Back EXIT Exit Favorite Channels Empty Empty Empty Empty Empty Empty Empty Empty Empty ANT 1 ANT 1 ANT 2 Edit Done To add a channel to the selected Favorite Channel list: Use Bb to highlight an unchecked box next to a channel you want to set as a favorite, and then press T to check the box. Note: You must first use Channel Program or Channel Add/ Delete to add channels to the channel memory before setting up favorite channels. 18 HM66 (E/F) Web 213:276