Toshiba 56HM66 Owner's Manual - English - Page 40

HM66_EN.book Page 40 Thursday, February 23, 2006 2:49 PM Chapter 5: Using the TV's basic features Displaying TV setting information on-screen using RECALL Understanding the auto power off feature To display TV setting information on-screen: Press E on the remote control. The following information will display on-screen (if applicable): STEREO NC-17 Sleep Timer: 18 min. Lamp High Bright Natural 480i ANT 1 CABLE 81-1 Sample RECALL screen • Current input (ANT 1, ANT 2, VIDEO 1, etc.) • If ANT 1 or ANT 2 is the current input, whether it is Cable TV ("CABLE") or off-air ("TV") • Channel number (if in ANT 1 or ANT 2 mode) • Signal strength indicator (bar graph in lower right corner of screen; for ATSC signal only) Note: The signal strength indicator will react to fading and increasing signals. • Remaining time on sleep timer (if set) • Stereo or SAP audio status • V-Chip rating status • Picture size • Video resolution • Lamp mode (appears only if the TV is in High Bright mode) To close the RECALL screen: Press E again. The TV will automatically turn itself off after approximately 15 minutes if it is tuned to a vacant channel or a station that completes its broadcast for the day. This feature functions in ANT 1 and ANT 2 modes only. Understanding the last mode memory feature If the power is cut off while you are viewing the TV, the Last Mode Memory feature automatically turns on the TV when the power is resupplied. Note: You should unplug the TV's power cord if it is possible that you will be away from the TV for an extended period of time after the power is restored. 40 HM66 (E/F) Web 213:276