Toshiba DW65X91 Owners Manual - Page 28
Learning Operating Code Of, Another Remote Control
View all Toshiba DW65X91 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
USING THE REMOTE LEARNING OPERATING CODE OF ANOTHER REMOTE CONTROL This remote control is capable of learning operating codes from most infared remote control transmitters. You can control the functions of your TV and a variety of video/audio equipment with the supplied remote control only. The A to H buttons can be used as the Learning buttons. 1. Set the USE/LEARN switch to the "LEARN" position. USE LEARN 2. Place the supplied remote control and the remote control transmitter to be learned, head to head approximately 1 to 3 inches (3 to 8 cm) apart. 9 6 3 POWER TV DVD VCR CABLE SWAP SOURCE POP TV/VCR PAUSE STOP SLOW ANTENNA STILL WHO 8 5 2 TV/VIDEO TV/SAT POWER TV/VCR 1 4 7 REW RLAY FWD Head to Head 1-3 inches apart GUID Supplied Remote Control Remote Control to be learned 3. Hold down the button to learn (A to H) on the supplied remote control for about 1 second until the LEARN indicator lights up. When you press a button other than a Learning button, the indicator will blink. 4. Hold down the button of the function to be learned on the other remote control transmitter for about 3 seconds until the LEARN indicator goes off. Note: If the LEARN indicator blinks, the supplied Remote Control cannot learn the operating code or an error has occurred. 5. Repeat steps 4 and 5 for storing other functions into other buttons. 6. Set the USE/LEARN switch to the "USE" position. FE SET SKIP+ O UDIO PO LEARN/ TV/VIDEO TV/SAT POWER TV DVD VCR CABLE REW RLAY FWD SWAP SOURCE POP TV/VCR PAUSE STOP SLOW ANTENNA STILL WHO GUIDE TCH INF UP TITLE SUB TITLE A O K (ENTER) P CH MENU SKIP- REC RETURN EXIT MUTE CH PIC SIZE VOL AB 123 CD 456 EF 789 G H OK 0 +100 / ENTER USE LEARN LEARN indicator EXIT MUTE Learning buttons USE/ LEARN switch USE LEARN 7. To check your programming, operate the appropriate equipment with the supplied remote control. If the equipment does not operate as expected, repeat steps 1 to 7. If needed, try changing the distance between the two remote controls. 28