Toshiba Portege R500 Maintenance Manual - Page 233
base cover assembly, black tape, screws, PC card cable, CN2110
View all Toshiba Portege R500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
4.6 Base cover assembly 4 Replacement Procedures 4. Remove the base cover assembly while lifting the LAN connector side first.(See figure 4-6) 5. Peel off the black tape from the middle frame. Black tape Figure 4-8 Removing the base cover assembly (3) Installing the Base cover assembly To install the base cover assembly, follow the steps below and refer to Figure 4-6 to Figure 4-8. 1. Set the base cover assembly in place. 2. Secure the base cover assembly with the following screws. • M2×4C S-THIN HEAD screw ×4 (Described as "A" in the figure) • M2×6C S-THIN HEAD screw ×10 (Described as "B" in the figure) • M2.5×6C S-THIN HEAD screw ×2 (Described as "C" in the figure) • M2×2.4C S-THIN HEAD screw ×1 (Described as "D" in the figure) 3. Connect the PC card cable to the connector CN2110 on the system board and insert the tab under the cover. 4. Stick the black tape to the middle frame in place. PORTÉGÉ R500 Maintenance Manual (960-634) [CONFIDENTIAL] 4-17