Toshiba Portege R500 Maintenance Manual - Page 244
DC-IN jack
View all Toshiba Portege R500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 244 highlights
4 Replacement Procedures 4.12 DC-IN jack 4.12 DC-IN jack Removing the DC-IN jack To remove the DC-IN jack, follow the steps below and refer to Figure 4-15. 1. Disconnect the DC-IN jack cable from the connector CN8800 on the system board and remove the DC-IN jack from the slot. Insulator DC-IN jack DC-IN jack cable Guide CN8800 Figure 4-15 Removing the DC-IN jack Installing the DC-IN jack To install the DC-IN jack, follow the steps below and refer to Figure 4-15. 1. Set the DC-IN jack into the guide of the slot and connect the DC-IN jack cable to the connector CN8800 on the system board. CAUTION: When installing a new DC-IN jack, stick a new insulator in place. 4-28 [CONFIDENTIAL] PORTÉGÉ R500 Maintenance Manual (960-634)
4
Replacement Procedures
4.12
DC-IN
jack
4.12 DC-IN jack
Removing the DC-IN jack
To remove the DC-IN jack, follow the steps below and refer to Figure 4-15.
1.
Disconnect the
DC-IN jack cable
from the connector
CN8800
on the system board
and remove the
DC-IN jack
from the slot.
Insulator
DC-IN jack
DC-IN jack cable
Guide
CN8800
Figure 4-15 Removing the DC-IN jack
Installing the DC-IN jack
To install the DC-IN jack, follow the steps below and refer to Figure 4-15.
1.
Set the
DC-IN jack
into the guide of the slot and connect the
DC-IN jack cable
to
the connector
CN8800
on the system board.
CAUTION
:
When installing a new DC-IN jack, stick a new insulator in place.
4-28
[CONFIDENTIAL]
PORTÉGÉ R500 Maintenance Manual (960-634)