Xerox 6180N DocuSP 61xx version 3.6 - Installation Planning Guide - Page 26
Passage A. - review
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Select and prepare an installation site You need to review these issues prior to, or at the time of, the site inspection conducted by your Xerox service representative. Required passage and doorway width Although the passageways may be wide enough to allow the modules to pass through, do not overlook the width of any doorways that must be used when delivering the equipment. The minimum required width for doorways is 35 inches (89 cm.) when the module can pass straight through. Required turning radius When the system modules must negotiate a corner during delivery, additional passageway width requirements must be considered. Such cases arise when a module must be able to turn to negotiate a corner, turn to pass through a door, or turn to enter an elevator. There are L-shaped turns and T-shaped turns. The diagrams and the tables that follow show the minimum space needed to maneuver through the turns. To use the tables, follow these steps: 1. Measure the minimum width of the passage or doorway through which the hardware module must be moved. This is Passage A. 2. Locate the number (or the next higher number) in the left column of Table 3-2. 3. Read across the row to the corresponding minimum value for Passage B, depending on the type of turn the equipment must negotiate (L-turn or T-turn). 4-8 DocuTech 61xx Installation Planning Guide