Xerox 6180N DocuSP 61xx version 3.6 - Installation Planning Guide - Page 49

5. Installation This chapter describes the activities you and Xerox perform during the installation of the Xerox DocuTech hardware and software components. Before installation can begin, you must complete the tasks described in the "Select and prepare an installation site" chapter. Installation process Xerox is responsible for the physical installation of the DocuTech printer hardware components and the initial loading of the Xerox DocuSP controller software. The installation process can take one or several days to complete. Equipment, software kits, and documentation kits may all arrive in one day or over the course of several days. When all necessary items are in place, the Xerox personnel will complete the installation of the DocuTech printer components. The steps in the installation process typically occur in the following order: 1. Xerox personnel install all DocuTech printer hardware and connect the DocuSP controller to the site network through the Ethernet connector you supply. This process takes approximately four hours if all of the necessary network and electrical connectors are in place. 2. Xerox personnel load the DocuSP software on the DocuSP controller. If optional Xerox software has been purchased, it is installed at this time. This process takes approximately 3 hours. 3. Xerox personnel install Xerox client software on one client workstation to validate the installation (15 minutes). All other client software installations are your responsibility. 4. Xerox personnel test the system and run sample jobs (30 minutes). 5. Xerox personnel conduct initial operations training (1 to 2 hours). DocuTech 61xx Installation Planning Guide 5-1