Xerox 6180N DocuSP 61xx version 3.6 - Installation Planning Guide - Page 44

Select and prepare an installation site Ordering supplies for the installation You need to order consumable supplies (those that are depleted during operation of the printer), such as paper, dry ink, developer, fuser agent, stitcher wire, and binder tape. It is important that you have an adequate supply on hand for installation and that you maintain the supply after installation. This section describes the supplies needed for installation. Your sales representative will help you place your initial order for supplies. The "Maintenance and support services" chapter provides you with the information you need to order additional supplies as you require them, a consumable supplies table, and a supplies checklist. Paper You need to select your paper carefully. If you do not use the proper paper, you increase the probability of paper jams and misfeeds. Acceptable paper stocks and sizes Paper trays 1 and 2 accept 8.5 by 11 inch, 9 by 11 inch, 9 by 14 inch, and A4 (210 by 297 mm) cut sheet paper. Paper trays 3, 4, and 5 accept paper up to 17 by 11 inches (432 by 279 mm). You can use standard white, colored, pre-drilled, and preprinted (letterhead and forms) paper, labels, and transparencies. The stock you use must meet the specifications set forth by Xerox for operability in the printer. For additional information about paper specifications, refer to the Xerox Document Services Platform Series DocuTech 61xx Operator Guide. Recommended weight and grade Use a good quality, xerographic-grade paper. For best results, use paper that is 20-pound or 75-grams per square meter (gsm) bond, xerographic grade. Xerox 4024 Dual Purpose Paper provides optimal performance in the printer. Refer to the consumable supplies table in the "Maintenance and support services" chapter. Use paper within these parameters: 4-26 DocuTech 61xx Installation Planning Guide