Yamaha HTR 6230 Owner's Manual - Page 21

INTRODUCTION PREPARATION BASIC OPERATION BASIC OPERATION Playback Caution Extreme caution should be exercised when you play back CDs encoded in DTS. If you play back a CD encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player before you play back a CD encoded in DTS. 5 Rotate PVOLUME (or press mVOLUME +/-) to adjust the volume to the desired output level. Basic procedure 1 Turn on external components (TV, DVD player, etc.) connected to this unit. 2 Press CSPEAKERS repeatedly to select the front speakers you want to use. The respective speaker indicators lights up on the front panel display. 3 Press NINPUT l / h repeatedly (or press one of the input selector buttons (f)) to select the desired input source. The name of the currently selected input source appears on the front panel display for a few seconds. Available input source DVR V-AUX DTV/CBL DVD MD/CD-R TUNER CD INPUT: DVD Currently selected input source 4 Start playback on the selected component or select a broadcast station. Notes • Refer to the operating instructions for the source component. • See page 27 for details about FM or AM tuning instructions. y • To adjust the level of each speaker, see page 19. y • See page 19 to adjust the level of each speaker. • This does not affect the AUDIO OUT (REC) level. • You can set the initial volume level and maximum volume level (see page 34). 6 Press LPROGRAM l / h (or press hAMP and then qPROG l / h) repeatedly to select the desired sound field program. The name of the selected sound field program appears on the front panel display. See page 21 for details about sound field programs. Movie Dramatic Currently selected surround field program Notes • Choose a sound field program based on your listening preference, not merely on the name of the program. • When you select an input source, this unit automatically selects the last sound field program used with the corresponding input source. • Sound field programs cannot be selected when the component connected to the MULTI CH INPUT jacks is selected as the input source (see page 18). • When PCM signals with a sampling frequency higher than 48 kHz are input, this unit is automatically set to the "STRAIGHT" mode (see page 26). • To display information about the currently selected input source on the front panel display, see page 20 for details. ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 17 En