Yamaha RX Z9 MCXSP10 Manual - Page 31
PREPARATION, FRONT OUT jacks, CENTER OUT jack, SURROUND jacks, PRESENCE jacks, SUBWOOFER jacks
UPC - 027108918204
View all Yamaha RX Z9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
PREPARATION ■ Connecting external power amplifiers If you want to increase the power output to the speakers, or want to use another power amplifier, connect an external amplifier to the pre out jacks. Notes • When RCA pin plugs are connected to the pre out jacks for output to an external amplifier, it is not necessary to use the corresponding SPEAKERS terminals. Set the volume of the amplifier connected to this unit to the maximum. • The signal output through the FRONT OUT, CENTER OUT and SUBWOOFER jacks is affected by the TONE CONTROL settings. • Signals will only be output from the FRONT OUT jacks if SPEAKERS B is set to "ZONE B" (see page 84) and SPEAKERS A is turned off (see page 84). OUT (SINGLE) (FRONT) L OUT POWER AMP IN SURROUND FRONT CENTER SURROUND BACK R (REAR) PRESENCE SUBWOOFER 1 23 4 5 6 1 FRONT OUT jacks Front channel line output jacks. 2 CENTER OUT jack Center channel line output jack. 3 SURROUND jacks Surround channel line output jacks. 4 SURROUND BACK jacks Surround back channel line output jacks. 5 PRESENCE jacks Presence channel line output jacks. 6 SUBWOOFER jacks Connect one or two subwoofer(s) with built-in amplifier, such as the YAMAHA Active Servo Processing Subwoofer System, to these jacks. Notes • Adjust the volume level of the subwoofer with the control on the subwoofer. It is also possible to adjust the volume level using this unit's remote control (see page 76). • Some signals may not be output from the SUBWOOFER jack depending on the Speaker Set (see page 74) and LFE Level (see page 70) settings. CONNECTIONS ■ Connecting external preamplifiers If you want to input signals from another preamplifier, connect the external preamplifier to the FRONT IN/ CENTER IN jacks. POWER AMP IN FRONT CENTER 12 1 FRONT IN jacks Line input to this unit's front channel amplifiers. When connecting to these jacks, signals input to this unit's preamplifier will not be output from the unit's front amplifier. 2 CENTER IN jack Line input to this unit's center channel amplifier. When connecting to this jack, signals input to this unit's preamplifier will not be output from the unit's center amplifier. ■ Connecting i.LINK components If you have a component with an i.LINK connector, you can enjoy digital audio from CD, DVD, Super Audio CD or DVD-A discs. S400 (AUDIO) i.LINK component English 27