Yamaha RX Z9 MCXSP10 Manual - Page 92
Setting manufacturer codes, component's manufacturer.
UPC - 027108918204
View all Yamaha RX Z9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
REMOTE CONTROL FEATURES Setting manufacturer codes You can control other components by setting the appropriate manufacturer codes. Codes can be set for each input area. The following table shows the input area (default component), component category (Library) and manufacturer code for each area. Input area V-AUX TUNER PHONO CABLE SAT MD/TAPE CD-R CD DTV/LD VCR 1 VCR 2 DVR DVD Component category (Library) VCR TUNER TV CABLE SAT MD CD-R CD TV VCR VCR DVD DVD Manufacturer code - YAMAHA 1 - - - YAMAHA 1 YAMAHA YAMAHA 1 - - - - YAMAHA 1 If you want to change a library (component category), press l / h to set a different component type. Library choices: L:DVD, L:LD, L:CD, L:CDR, L:MD, L:TAP, L:TUN, L:AMP*, L:TV, L:CAB, L:DBS, L:SAT, L:VCR * The amplifier Library (L:AMP) code is preset to "YPC" to operate this unit. However, you can switch between the following four codes if necessary. YPC To operate this unit (without ZONE 2 features). ZONE To operate this unit (with ZONE 2 features). DSP To operate YAMAHA DSP amplifiers that cannot be operated with the YPC code. NO To operate the amplifiers of other manufacturers using this unit's remote control. 3 Press k/n to select the name of your component's manufacturer. You will find the names of most worldwide audiovideo manufacturers in alphabetical order in the display window. ENTER Note You may not be able to operate your YAMAHA component even if a YAMAHA manufacturer code is initially set as listed above. In this case, try to set another YAMAHA manufacturer code(s). 1 Press an input selector button to select the source component you want to set up. V-AUX TUNER PHONO CABLE SAT MD/TAPE CD-R CD DTV/LD VCR 1 VCR 2 DVR DVD 2 Press and hold LEARN for about 3 seconds using a ballpoint pen or similar object. "SETUP" and the selected component name appear alternately in the display window. LEARN 4 Press one of the buttons shaded below to see if you can control your component. If you can, the manufacturer code you set is correct. PURE DIRECT TITLE MULTI CH IN SOURCE INPUT MODE DISPLAY TOP MENU SELECT SEARCH ENTER EXIT SOUND - CHAPTER + POWER REC STOP PAUSE PLAY y • If more than one code is listed for the manufacturer of your component, try each of them until you find the correct one. • If you want to continue setting up a code for another component, press ENTER and repeat steps 1, 3 and 4. Be sure to press down LEARN for at least 3 seconds, otherwise the learning process will start. y Complete each of the following steps within 30 seconds. Otherwise, the learning mode is automatically canceled. In this case, press LEARN again. 88