Yamaha RX Z9 MCXSP10 Manual - Page 38
Starting the setup, For Wiring, Distance, Size or Level, select
UPC - 027108918204
View all Yamaha RX Z9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
AUTO SETUP Starting the setup For best results, make sure the room is as quiet as possible during the auto setup procedure. If there is too much ambient noise, the results may not be satisfactory. y If your subwoofer can adjust the output volume and crossover frequency, set the volume to about half way (or slightly less), and set the crossover frequency to the maximum. 1 Switch on the unit and video monitor, then press TOP on the GUI remote control. The TOP display appears. 3 Press k/n repeatedly to select Setup Menu, then press h. ENTER TOP EXIT GUI remote control 4 Press k/n repeatedly to select Wiring, Distance, Size, Equalizing or Level. 2 Press k/n repeatedly to select Auto Setup, then press h. ENTER ENTER For Wiring, Distance, Size or Level, select: Check Skip To automatically check and adjust the selected item. To skip the selected item and perform no adjustments. y When using THX speakers, select Skip and make sure that Small or Small x2 is selected in Speaker Set (page 74) and that 80Hz is selected in Cross Over (page 76). 34