Yamaha RX Z9 MCXSP10 Manual - Page 96
Macro operations, Programming macro operations, Set MACRO ON/OFF to ON.
UPC - 027108918204
View all Yamaha RX Z9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
REMOTE CONTROL FEATURES ■ Macro operations TRANSMIT RE-NAME CLEAR LEARN MACRO MACRO OFF ON SYSTEM POWER STANDBY V-AUX TUNER PHONO CABLE SAT MD/TAPE CD-R CD DTV/LD VCR 1 VCR 2 DVR DVD PURE DIRECT TITLE MULTI CH IN MACRO MACRO ON/OFF Macro buttons 1 Set MACRO ON/OFF to ON. 2 Press a macro button. Notes • When you have finished using the macro feature, set MACRO ON/OFF to OFF. • While the remote is carrying out a macro program, it will not accept any other button's function until the macro operation is complete (the TRANSMIT indicator stops flashing). • Continue to aim the remote control at the component the macro is operating until the macro operation is complete. ■ Programming macro operations You can program your own macros and use the macro feature to transmit several remote control commands in sequence at the press of a button. Be sure to set up manufacturer codes or perform learning operations before programming the macro. We do not recommend programming continuous operations such as volume control in a macro. Notes • The default macro is not cleared when a new macro is programmed for a button. The default macro can be used again when the programmed macro is cleared. • It is not possible to add a new signal (macro step) to the default macro. Programming a macro changes all macro contents. 1 Press MACRO using a ballpoint pen or similar object. "MCR ?" appears in the display window. MACRO 2 Press the macro button you want to use to operate the macro. The macro button name and the selected component name appear alternately in the display window. V-AUX TUNER PHONO CABLE SAT MD/TAPE CD-R CD DTV/LD VCR 1 VCR 2 DVR DVD Flashes alternately Notes • "AGAIN" appears in the display window if you press a button other than a macro button. • To change the selected source component, press SOURCE SELECT k/n. Pressing the input selector buttons will program a macro step, whereas SOURCE SELECT k/n only changes the selected component and corresponding component control area. 3 Press the buttons for the functions you want to include in the macro operation in sequence. You can set up to 10 steps (10 functions). After you have set 10 steps, "FULL" appears and the remote control automatically exits from the macro mode. SYSTEM POWER STANDBY V-AUX TUNER PHONO CABLE SAT MD/TAPE CD-R CD DTV/LD VCR 1 VCR 2 DVR DVD PURE DIRECT TITLE MULTI CH IN SOURCE INPUT MODE DISPLAY TOP MENU SELECT SEARCH ENTER EXIT SOUND - CHAPTER + POWER REC STOP PAUSE 1 PLAY 2 MCR 1: DVD a MCR 2: DVD h Indicates the number of macro steps entered y Complete each of the following steps within 30 seconds. Otherwise, the learning mode is automatically canceled. In this case, press MACRO again. Flashes alternately so you can set the next step Note "NG" appears in the display window if programming was unsuccessful. In this case, start over from step 2. 92