Yamaha YSP800S Owner's Manual - Page 34
Preparation, Optimz, Beam Optimz Only Or Sound
UPC - 027108923543
View all Yamaha YSP800S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
AUTO SETUP 5 Press / to select BEAM OPT+SOUND OPTIMZ, BEAM OPTIMZ only or SOUND OPTIMZ only and then press ENTER. The following screen appears on your TV. 6 Press / / / to select and configure each parameter and then press ENTER. ENTER ENTER ENTER p p PREPARATION . INSTALLING;;Parallel to Wall MOUNTING;;;;SHELF REFLECTING;;NORMAL Set MIC in front of YSP MIN 2m/6.5ft [ ]/[ ]:Up/Down/[p]/[ ]:Sel [ENTER]:Start p INSTALLING (Installing) Use to select the installed position of the unit in your listening room. Choices: Parallel to Wall (Parallel with wall installation), Angle to Wall or corner (Corner installation) Angle to Wall or corner Parallel to Wall BEAM OPT+SOUND OPTIMZ (Beam optimization and YPAO sound optimization) Use to optimize the beam angle, delay, volume and quality so that the parameters best match your listening environment. It is recommended that you should select this optimization feature in the following cases: • If you make settings for the first time. • If the unit has been relocated. • If your listening room has been restructured. • If the objects in your listening room (furniture, etc.) have been rearranged. BEAM OPTIMZ only (Beam optimization only) Use to optimize the beam angle so that the parameter best matches your listening environment. SOUND OPTIMZ only (YPAO sound optimization only) Use to optimize the beam delay, volume and quality so that the parameters best match your listening environment. It is recommended that you should select this optimization feature in the following cases: • If you have opened or closed the curtains in your listening room before using this unit. • If you have manually set the beam angle. • Select Angle to Wall or corner if the unit is installed in the corner. The beam mode is set to ST+3BEAM (see page 41). • Select Parallel to Wall if the unit is installed in parallel with the wall. The beam mode is set to 5BEAM (see page 41). Note You must optimize the beam angle in the BEAM OPTIMZ only procedure before starting the SOUND OPTIMZ only procedure. 30