Yamaha YSP800S Owner's Manual - Page 44

BEAM MODE BEAM MODE You can change the beam mode to suit the input source of this unit using the beam mode buttons on the remote control (STEREO, 3BEAM, 5BEAM, ST+3BEAM or TARGET). Select stereo mode for 2-channel sources, 3 beam mode, 5 beam mode and stereo plus 3 beam mode for 5.1-channel playback. All the beam modes are available in the following cases: • If you selected Parallel to Wall for INSTALLING in AUTO SETUP (see page 30) • If you selected settings other than CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC SETUP (see page 59) • If you selected FLAT TO WALL for INSTALLED POSITION in MANUAL SETUP (see page 65) Only stereo, stereo plus 3 beam and target modes are available in the following cases: • If you selected Angle to Wall or corner for INSTALLING in AUTO SETUP (see page 30) • If you selected CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC SETUP (see page 59) • If you selected ANGLE TO WALL OR CORNER for INSTALLED POSITION in MANUAL SETUP (see page 65) AUTO SETUP BASIC SETUP MANUAL SETUP Beam mode INSTALLING (see page 30) Parallel to Wall Angle to Wall or corner INSTALLED POSITION (see page 59) CORNER RIGHT or CORNER LEFT Other settings INSTALLED POSITION (see page 65) FLAT TO WALL ANGLE TO WALL OR CORNER STEREO Yes Yes Yes Yes Yes Yes 3BEAM Yes No No Yes Yes No 5BEAM Yes No No Yes Yes No ST+3BEAM Yes Yes Yes Yes Yes Yes TARGET Yes Yes Yes Yes Yes Yes Note Yes: the corresponding beam mode is available. No: the corresponding beam mode is not available. 40