Yamaha YSP800S Owner's Manual - Page 76

MANUAL SETUP ■ INPUT MODE (Input mode) Use to designate the input mode for the input sources connected to the DIGITAL INPUT jacks when you turn on the power of this unit. For information on the types of audio signals that can be output by this unit, see "Surround modes and recommended sources" on page 44. Choices: AUTO, LAST B)INPUT MODE )AUTO LAST p [ ]/[ ]:Select [ENTER]:Retern ■ INPUT RENAME (Input rename) Use to change the name of the input source in the OSD and the front panel display. Press an input selector button (TV, STB, DVD, VCR, or AUX) to select the component you want to change the name for and then perform the following procedure. D)INPUT RENAME AUX -> AUX p [ ]/[ ]:Position [ ]/[ ]:Character [ENTER]:Return p p p p p p p • Select AUTO to allow this unit to automatically detect the type of input signal and select the appropriate input mode. • Select LAST to set this unit to automatically select the last input mode used for that input source. If the type of input signal is different from the setting, no sounds will be produced. ■ INPUT TRIM (Input trim) Use to adjust the input level of the input source. C)INPUT TRIM (. TV ANALOG;;;;;-3.0dB (. OPTICAL;;;;-3.0dB (. VCR ANALOG;;;;;-3.0dB (. AUX OPTICAL;;;;-3.0dB (. DVD COAXIAL;;;;-3.0dB p [ ]/[ ]:Up/Down[ ]/[ ]:Sel [ENTER]:Return 1 Press TEST on the remote control. TEST 2 Press / to place the _ (underbar) under the space or the character you want to edit. The _ (underbar) flashes. ENTER • Select TV ANALOG to adjust the level of audio and video signals input at the TV/STB analog audio input jacks of this unit. Control range: -6.0 dB to 0.0 dB Initial setting: -3.0 dB • Select TV OPTICAL to adjust the level of audio and video signals input at the TV OPTICAL IN jack of this unit. Control range: -6.0 dB to 0.0 dB Initial setting: -3.0 dB • Select VCR ANALOG to adjust the level of audio and video signals input at the VCR analog audio input jacks of this unit. Control range: -6.0 dB to 0.0 dB Initial setting: -3.0 dB • Select AUX OPTICAL to adjust the level of audio and video signals input at the AUX OPTICAL IN jack of this unit. Control range: -6.0 dB to 0.0 dB Initial setting: -3.0 dB • Select DVD COAXIAL to adjust the level of audio and video signals input at the COAXIAL IN jack of this unit. Control range: -6.0 dB to 0.0 dB Initial setting: -3.0 dB 3 Press / to select the desired character. • You can use up to 8 characters for each input. • Press to change the character in the following order or press to go in the reverse order: A to Z, a space, 0 to 9, a space, a to z, a space, #, *, +, etc. ENTER 72