Yamaha YSP800S Owner's Manual - Page 70
Asetting Parameters 2/3, Bbeam Adjustment, Ahorizontal Angle 1/5, Beam Adjustment Beam Adjustment
UPC - 027108923543
View all Yamaha YSP800S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
MANUAL SETUP • Select ANGLE TO WALL OR CORNER if this unit is installed in the corner in your listening room. Adjust the width and length of your listening room as well as the distance of the listening position from this unit and the distance of the center of this unit from the left wall. Listening position from the unit Room width ■ BEAM ADJUSTMENT (Beam adjustment) Use to manually adjust the various speaker beam angles. We recommend that you select 5 beam mode before adjusting these parameters. Notes • When INSTALLED POSITION is adjusted in BASIC SETUP (see page 59) or MANUAL SETUP (see page 65), the factory default value is automatically set for this parameter except when FOCAL LENGTH is set to CENTER (see page 67). • Depending on the beam mode settings (see page 40), some speaker positions may not be available for selection. In this case, "- -" is displayed. When using the stereo plus 3 beam mode, set the surround left and right signals to be output from the front left and right speakers. Room length Choices for the room width and length: 2.0 m to 12.0 m (6.5 ft to 40.0 ft) Choices for the listening position from this unit: 2.0 m to 9.0 m (6.5 ft to 30.0 ft) Choices for the listening position from the left wall: 0.6 m to 11.4 m (2.0 ft to 38.0 ft) A)SETTING PARAMETERS 2/3 Room width and length p p 12.0m 12.0m p [ ]/[ ]:Up/Down[ ]/[ ]:Sel [ENTER]:Return B)BEAM ADJUSTMENT . a)HORIZONTAL ANGLE b)BEAM TRAVEL LENGTH c)FOCAL LENGTH d)TREBLE GAIN [ ]/[ ]:Up/Down [SELECT]:Enter HORIZONTAL ANGLE (Horizontal angle) Use to adjust the horizontal angle of beams for each speaker. By adjusting the horizontal angle of the beams, you can optimize the sound beam paths. A test tone is automatically output. (−) (+) (+) (−) p p p p p p p Listening position from the unit and the left wall A)SETTING PARAMETERS 3/3 12.0m p p p [ ]/[ ]:Up/Down[ ]/[ ]:Sel [ENTER]:Return Note When you set the INSTALLED POSITION parameter in BASIC SETUP (see page 59) or MANUAL SETUP (see page 65), the parameters newly set for the width and length of your listening room are automatically set as the factory default value. Choices: L90° to R90° Adjust towards L (left) to move the direction of the output to the left and adjust towards R (right) to move it to the right. a)HORIZONTAL ANGLE 1/5 3BEAM Front L L60deg L90 R90 * 0(deg) p [ ]/[ ]:Up/Down[ ]/[ ]:Sel [ENTER]:Return 66