2008 Acura RL Owner's Manual - Page 177

Main Menu Table Of Contents Keyless Access System Also, if you close the door when the ignition switch is not in the LOCK (0) position and the remote is not inside the vehicle, the keyless access alarm sounds outside the vehicle, a message appears on the multiinformation display, and the beeper sounds if the ignition switch is in the ON (II) position. When the beeper sounds after you close the driver's door outside the vehicle, check the position of the ignition switch and the location of the remote. If the engine is running and you remove the remote from the vehicle, it will continue to run. But once turned to the LOCK (0) position, the engine will not restart until a remote is brought back into the vehicle. Removing the Ignition Switch Cover IGNITION SWITCH COVER Beeper and Message Keyless Remote Not Detected pull push BUILT-IN KEY To remove the ignition switch cover, insert the built-in key (see page 177 ), then pull the cover out by pulling the built-in key while pushing it. When you are pressing the ignition switch, or when the ignition switch is in the ON (II) position, the beeper sounds if you take the remote out of the vehicle and close the door. 174 2008 RL