2008 Acura RL Owner's Manual - Page 299

Main Menu Table Of Contents HomeLink Universal Transceiver If you are training the second or third buttons, go directly to step 1. 1. Hold the end of the garage door opener remote transmitter 1 to 3 inches from HomeLink. Make sure you are not blocking your view of the red indicator in HomeLink. RED INDICATOR If the red indicator in HomeLink begins to flash slowly at first, then rapidly, release both buttons, and go to step 4. If the red indicator in HomeLink continues to flash slowly (does not flash rapidly), your remote transmitter may stop transmitting after a short time. Go to step 3. 3. Press and hold the remote transmitter button and one of the HomeLink buttons at the same time. While continuing to hold the HomeLink button, press and release the remote transmitter button every 2 seconds. If the red indicator in HomeLink begins to flash slowly at first, then rapidly, release both buttons, and go to step 4. If the red indicator in HomeLink continues to flash slowly (does not begin to flash rapidly), repeat steps 1 thru 3. 4. Test the HomeLink button by pushing it for about 1 second. If the button works, programming is complete. If the button does not work go to step 5. 5. Push and hold the HomeLink button and watch the red indicator on HomeLink. If the indicator stays on, press the HomeLink button again; the remotely controlled device should operate. If the indicator flashes rapidly for 2 seconds then stays on, you have a rolling code transmitter: go to ''Training with a Rolling Code System'' (see page 297 ). 2. Press and hold the remote transmitter button and one of the HomeLink buttons at the same time. 296 2008 RL