2008 Acura RL Owner's Manual - Page 84

Main Menu Table Of Contents Multi-Information Display Customized Settings With the multi-information display and the INFO ( / ) and SEL/ RESET buttons on the right side of the steering wheel, you can customize some vehicle control settings for ''DRIVER 1'' or ''DRIVER 2''. If ''DRIVER 1'' or ''DRIVER 2'' is not displayed, customizing is not possible. To have the driver's ID detected, make sure your remote is linked to the system (see Memory Position Link on page 104 ). Then use your remote to unlock the doors (see Keyless Access Setup on page 108 ). To change the settings, the ignition switch must be in the ON (II) position, and the vehicle must be stopped with the transmission in Park. To enter the customizing mode, press and hold the INFO ( / ) button for more than 3 seconds while the multi-information display is in its normal mode. Instruments and Controls If you turn the ignition switch to the ACCESSORY (I) or the LOCK (0) position, or move the shift lever out of Park, the display will change to the normal screen. You cannot customize the settings under these conditions: When the keyless memory settings are off (see page 170 ). If you disconnect the battery, and then do not unlock the door. When the multi-information display does not show the driver's ID. The first customizing menu is: CHG SETTING (see page 87 ) DEFAULT ALL (see page 85 ) Refer to the following table for a brief summary of each customizable setting and its default. For more information, refer to the page number references in the table. CONTINUED 2008 RL 81